These sturdy weld-in engine mounts allow the installer to
fine-tune the engine placement according to transmission
placement or other needs. A double rubber cushion on each
side provides vibration isolation at the ends of the two
mounts. The rubber cushions are secured with a large 5/8”
diameter bolt. The engine side mounts have holes in them
so you can position the engine closer to one side of the
frame.
The engine mount kit includes two engine side mounts, two
weld-in gusseted frame mounts, and rubber mount kit.
Note: These engine mounts fit the new Gen III / IV ,
LS-Series V8. The mounts have been designed to use with
Truck exhaust manifolds or rear dump headers and will
interfere with car (Corvette / Camaro / Trans-Am) exhaust
manifolds.
Note: These engine / motor moounts are commonly used with
Jeep YJ Wrangler and Jeep CJ Models
Scout, Traveler, Terra and Travelall are trademarks of Scout Motors Inc. Their use has been licensed under Scout/Light Line Distributors, Inc. - IH Parts America is a Scout/Light Line Authorized Dealer.
